All buildings require ventilation to rid the dwelling of stale air, exhaust indoor toxins, and to protect the structure from damaging effects of excess moisture. With today's tighter homes, a controlled, well-designed ventilation system is necessary.
Ceiling Fans
Panasonic Super-Quiet Exhaust Ceiling Fan
Panasonic has designed a fan to meet the task with the utmost in energy efficiency. The low sone (noise) level and low input wattage allow these fans to run continuously and quietly.
PE FV05VQ 50CFMs, .5 sones 13 watts $135.90
PE FV07VQ 70CFMs, .5 sones 14 watts $142.80
PE FV08VQ 90CFMs, 1 sones 17.4 watts $148.72
PE FV11VQ 110CFMs, 1.5 sones 20 watts $161.32
PE FV20VQ 190CFMs, 1.5 sones 32.5 watts $247.16
PE FV35VQ 340CFMs, 3 sones 95 watts $354.12
Same fan as above with a built-in light fixture. Includes two 13-watt Panasonic compact fluorescent (equals two 60-watt bulbs but rated for 1000 hours.)
PE FV07VQ 70CFMs $200.78
PE FV08VQ 90CFMs $210.82
PE FV11VQ 110CFMs $225.08
Use 4 inch duct with models PE FV05VQ, PE FV07VQ, PE FV08VQ, PE FV11VQ, PE FV07VQ, PE FV08VQ, PE FV11VQ. Use 6 inch duct with models PE FV20VQ, PE FV35VQ.
Wall-mounted Fans
Panasonic Whisperwall wall-mounted Fan
Because of its unique condenser motor design, this fan is rated to run continuously while using 1/4th the electricity of the typical wall fan. It can be used as a spot fan to clear out temporary moisture and odors, or left running for continuous exhaust of stale, indoor air. The price includes a flexible duct and a sturdy galvanized exterior wall grill.
PE FV08W 80 CFMs, .45 sones, 16 watts $216.50
Fantech In-line - The Fantech In-line fan is designed to be installed between sections of round duct. The remote installation insures a low sound level at the grill. Because the housing is made of
Noryl plastic, the fan can be mounted in outdoor and wet locations. In addition, the fan is sealed to prevent moisture from entering the housing and to prevent leakage if the fan is to be used for radon mitigation. With the use of a Y-connector, a single in-line fan can ventilate two areas.
Remote Mount Fans
The Fantech 100 Kit
Contains one 108 CFM (4 inch duct, 48 watt input) fan, one bracket, one grill/collar/damper combination and clamps. This model is rated to ventilate up to 85 sq. ft.
PE REG 100 KIT $226.74
The Fantech 150 Kit
same as above with 213 CFM (6 inch duct, 90 watt input) fan to ventilate 120-210 sq. ft.
PE REG 150 KIT $227.60
Dual Point Exhaust Kits
The Fantech Deluxe 150 Kit
Adds a Y connector, an extra grill combo and extra clamps
PE DELUX 150 KIT $226.60
The Fantech Deluxe 200 Kit
Uses a 360 CFM (8 inch duct and 128 watt input) fan to ventilate 210 to 340 sq. ft. with all of the above accessories.
PE DELUX 200 KIT $362.00
The Adles SPV (Single Port Vent) - The Adles SPV allows for ventilation of several areas with a single fan. It is energy efficient, quiet (.5 to 1 sone at the grill) and suitable to a wide range of applications. A special feature of the SPV's is its flat fan curve which insures a relatively constant pressure over a wide range of airflow. This means that SPV can be used with longer duct runs without significantly affecting pressure or noise level. The SPV can be used to vent range ducts.
Single Port Vent Fans
Adles SPV 275 CFM Fan
See above for info.
PE SPV200 6 inch duct $413.20
Dual Exhaust Point Package
Includes SPV 200 330 CFM fan, adjustable air grills, sleeves with back draft
damper, chain set for suspending fan, Y fitting, duct straps.
PE DELUX SPV 200 $510.56
Range Exhaust Package
Includes 275 CFM fan, back draft damper, sound absorber and chain set for suspending fan.
PE SPV200 $495.14
PE SPV300
Same as above with larger 330 CFM fan.
PE SPV300 8 inch duct $571.36
The ERV System - Energy efficient buildings of today can be so tight that they eliminate virtually all air leaks. GREAT! - but an unwanted side effect is the constant recirculation of stale air containing the build-up of pollutants, odors, carbon dioxide and excessive moisture. Letting in fresh air through an open window, an obvious solution, carries its own set of problems, not the least of which is to heat this cold air in winter and cool it in summer. The solution - a heat recovery ventilator (HRV) which uses room air to preheat incoming air. An ERV, one further step, also maintains a good indoor humidity level, and pre-cools incoming summer air. ERV means cleaner, fresher, healthier air.
Whole House Ventilators
Whole House Attic Fan
NOCTURNAL Cooling
Air Conditioning; an Avoidable Expense, with NIGHT Cooling by the Silent Night Fan & good insulation, can yield cost
avoidance of $0.72/hour (operation cost Air Conditioning).
Introducing the First Technical advance in Whole-House Cooling Fans in more than 40 years
Automatic Operation with two efficient lift motors operate the insulated doors to an 85 degree angle in use, then sealed when off & closed Energy Efficient Fan Motors drawing only 36 watts each (conventional comparison 30"fan = 480 watts)
Power 120 VA 60 Hz; 2 Fans @ 60 watts each; 2 Motors @ 3 watts each ; Open/Close Time 30 seconds; Rough open 14.25" x 22.25" ; Air Flow 1000 CFM @ 0.1" static; R-value closed R22 ; Weight 16 lbs. ;Wiring Required 14-3 ; Housing Deflection Temperature 180 degrees F
PE HV1000 All Parts, including the 1000 CFM fan, inside grill, with on/off switch $650
Lossnay Energy Recovery Ventilator (ERV)
The Mitsubishi core of this product is an engineered composite resin partition plate. Fresh incoming air is automatically preheated or
pre-cooled by the core depending on the season. As opposed to an HRV (Heat Recovery Ventilator) an ERV exchanges humidity as well as heat in winter. The core works to prevent indoor humidity levels from becoming too dry or too humid by the partial transfer of water vapor. By the same method, summer outside air brought in for ventilation is reduced in temperature and humidity because its heat and moisture are transferred to the exhaust air stream. The core in this system stays frost free, requiring no antifreeze cycle. This mechanical simplicity means low maintenance and less energy usage.
PE HE110 for homes up to 2350 sq. ft. 120 VAC 30in. x 20in. x 12in. 110 CFM $818.84
PE HE210 for homes up to 4500 sq. ft. 240 VAC 30in. x 20in. x 21in. 210 CFM $1250.92
Fan Installation Accessories
Fantech Polypropylene Hush Grills
These grills can be used for supply or exhausted air. They are easy to install, adjustable and super quiet.
PEHG4 for 4in. duct $14.33
PEHG5 for 5in. duct $17.28
PEHG6 for 6in. duct $17.70
PEHG8 for 8in. duct $28.15
Y Fittings
These fittings, made of sheet metal, are used for splitting duct runs. They come in connector sizes to accommodate 3in. to 6in. ducting and 8in. ducting.
PE Y36 3-6in. ducting $15.10
PE Y8 8in. ducting $22.10
Butterfly Dampers
For fans that do not have built-in back draft dampers, our butterfly dampers should be used to prevent cold air from entering the house. The
Famco dampers are galvanized and have a high-quality foam seal to prevent air infiltration. They can be used in either vertical or horizontal applications.
PE B4 for 4in. duct $10.48
PE B5 for 5in. duct $12.88
PE B6 for 6in. duct $13.34
PE B7 for 7in. duct $12.30
PE B8 for 8in. duct $13.25
Insulated Flex Duct
This ducting is used when ducting must run through an unconditional space. in general, please remember that flexible ducting will insure a decreased noise level over rigid duct. 4in. x 24in. (other sizes available) R-4
PE FD4 4in. x 24in. $23.08
PE FD6 6in. x 25in. $30.88
PE FD8 8in. x 25in. $35.12
Famco Plastic
Damper Vents
Famco plastic damper vents have a long tail piece that makes an easy connection with insulated ducting.
PE DV 4in. or 5in. $7.60
PE DV 6in. $9.70
Broan Kit
The Broan Kit includes roof cap, 8in. x 4in. vinyl hose, clamp, connector and reducer.
PE RC $39.64
The Heartland Vent
This vent can be used as a dryer or fan vent. It an be exterior wall or roof mounted. This model is far superior to a standard louvered vent in several ways. First, the unique closure system prevents drafts from entering and keeps out leaves and outside debris, which can clog louvered vents. Additionally, the thermal plastic closure doesn't conduct heat as metal does, and it reflects moisture to retard frost formation. These vents are available with a spring-loaded shuttle for use with low-pressure fans.
PE HL $21.840